Measurement-computing Micro 488/EX rev.2.1 Instrukcja Użytkownika Pobierz pdf (Strona 108)

Section 5 Command Descriptions

5.38

The

command allows the user to change the

or the

command character

to any printable ASCII character. If the double

character command is issued, the

character will default back to '

The desired character must immediately follow the semi-colon without

intervening spaces. The

and

command can be disabled by not including, eg

ending the command with either a CR or LF character, the character following the

required semicolon. It can be re-enabled again by issuing the

command with a valid

character.

If the

character and

TIME

OUT

s are disabled, and an invalid bus address is

specified within a command, the only way to recover control is by re-powering the

interface. If you anticipate that the

data

part of an

OUTPUT

SEND

command may

contain the presently programmed

character, it should be disabled.

SYNTAX

ID;

[

ASCII

]

ASCII

is any printable ASCII character immediately following the

semi-colon (

;

)

RESPONSE None

MODE Any

BUS STATES None

EXAMPLES

PRINT #1,"ID;#"

change the ID character to #

PRINT #1,"ID;"

disable the ID commands

PRINT #1,"ID;@"

re-enable the ID character to @

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 217 218

Komentarze do niniejszej Instrukcji

Brak uwag

Measurement-computing Micro 488/EX rev.2.1 Instrukcja Użytkownika Strona 108

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Sprzęt komputerowy Measurement-computing Micro 488/EX rev.2.1