Measurement-computing Analyzer488 Instrukcja Użytkownika Pobierz pdf (Strona 257)

Appendix B Serial Controller Command Summary

B.1

PPOLL CONFIG PPOLL CONFIG addr;response

Set the Parallel Poll response of a bus device.

PPOLL DISABLE PPOLL DISABLE addr[,addr

...

]

Disable a bus device from responding to parallel polls.

PPOLL UNCONFIG PPOLL UNCONFIG

Prevent all bus devices from responding to a Parallel Poll.

PRINT ?[[location]TO[location]|[location]LENGTH

[count]|BUS]

Returns bus data or record memory data.

READ READ

Accept data from the bus while in low-level mode.

RECORD RECORD{[?]|[ON|OFF]}

Start or stop recording bus events.

RELATIVE RELATIVE{[?]|[ON|OFF]}

Toggles Relative Addressing Format.

REMOTE REMOTE[addr[,addr

...

]]

Assert Remote Enable line or address devices to listen.

RESET RESET

Analyzer488 warm start.

RESUME RESUME

Un-assert Attention (ATN) line.

SEND SEND[;]sub-command[sub-command

...

]

Send low level sequences in High Level Controller Mode.

SET RELATIVE SET RELATIVE{[?]|[location]}

Specify record memory reference pointer.

SET TRIGGER SET TRIGGER{[?]|ON|OFF][MATCH[state]

[line][byte]][# OF MATCHES[match count]]

[TRIG DELAY[delay]][POST COUNT[post count]]

[WHEN COMPLETE[STEP|STOP]]}

Configure triggering parameters.

1 2 ... 252 253 254 255 256 257 258 259 260 261 262 ... 280 281

Brak uwag

Measurement-computing Analyzer488 Instrukcja Użytkownika Strona 257