
Daq* Hardware DaqBook/260
DaqBook/DaqBoard/Daq PC-Card User’s Manual
1-14-00
3-13
4 – Remove termination panels
Remove the two screws mounting each termination panel to the card drawer.
P1 Interconnect Board
DaqBook/200 sits
on a shelf above
the card drawer
Card Drawer to Chassis Connector
Termination Panel
(1 of 3)
JP1 Jumper
Step 6B
JP2 Jumper
Step 6A
Standoff
(2 per card)
Card Drawer
DBK Card to
Interconnect Board
Steps 7A and 10A
Top C over
()
cut-away view
Internal DB37 connects
to DBK cards. (1 of 3)
DaqBook/260 Hardware Setup
Thumbscrew
(1 of 3)
Steps 3B and 13C
Termination Panel to
Card Drawer Screws
Steps 4 and 12
DBK Card to
Card Drawer Screws
Steps 7B and 10B
Card Drawer to
Chassis Screw
(1 of 2)
Steps 3A and 13D
Card Drawer to
Chassis Screw
(1 of 2)
Steps 3A and 13D
Top Cover Screws
Steps 2 and 15
5 – Determine power requirements
Depending on the power needs of your system’s DBK cards, you may need to add a power card. Refer to
Calculating Your Power Needs
in chapter 7.
A.
Use the
DBK Power Requirements Worktable
to calculate the power requirements of your system’s DBK
cards.
B.
Use the
Available Power Chart
to determine your system’s power availability.
C.
If the required power in step 5A is more than the available power in step 5B, you need an additional power
card. There are three auxiliary power supply cards:
•
DBK32A – For use with a LogBook, DaqBook, or DaqBoard. It supplies ±15 V.
•
DBK33 – For use with a Log Book, DaqBook, DaqBoard, or Daq PC-Card. It supplies +5 V and ±15 V.
•
CDK10 – For use with a Daq PC-Card. It supplies +5 V and ±15 V. The power source is housed in its
own expansion chassis.
Komentarze do niniejszej Instrukcji