Measurement-computing Daq PC-Card Instrukcja Użytkownika Pobierz pdf (Strona 13)

457-0941, rev 1.2

1-10-00

DaqBook Quick Start Guide 1- 5

To verify connections, turn

the power switch by rotating the rocker-arm switch to the “

” position. The

POWER LED

should

light up.

If connecting your DaqBook to a notebook PC

, you can use a

WBK20A, PCMCIA Interface Card. Refer to separate instructions

(supplied with the WBK20A) if applicable.

If connecting your DaqBook to a desktop PC (with no available

EPP port),

you can use a WBK21 Interface card. Refer to separate

instructions (supplied with the WBK21) if applicable.

Reference Note:

It is possible to use a different VDC power source (instead of the adapter); however, you should

consult the Power Management Section of your user’s manual before doing so.

(4) Install Software

Remove previous version Daq* drivers, if present. You can do

this through Microsoft’s Add/Remove Programs feature by

navigating from your desktop as follows:

Start ⇒ Settings ⇒ Control Panel ⇒ Add/Remove Programs

Place the Data Acquisition Software CD in the host PC’s

CD-ROM drive.

Wait for PC to auto-access the CD. This

may take a few moments, depending on your PC.

If a Licensing Agreement appears, read over the agreement,

then click “Agree.” The Data Acquisition Software Master

Setup Screen appears (see figure at right).

Select

DaqBook/DaqBoard Support.

For Windows95/98/NT

(or more recent Windows), select

32-bit

If using Windows3.1, or DOS,

select

16-bit

instead of 32-bit.

If you do not have Acrobat Reader version 3.0 or greater

installed on your PC, select

Acrobat Reader

. This will

enable you to read and print documentation that is included

on the install CD-ROM.

Select

DIAdem Post Acquisition Data Analysis

Program

. Refer to your separate DIAdem document

(p/n 457-0903) for information regarding DIAdem.

Click “

Start Install

.”

Follow screen prompts.

(5) Test Hardware

Run the

Daq Configuration

control panel applet.

Click “

Add Device

.”

Select your DaqBook model from the “

Device Type

” scroll box and click

Select your DaqBook from the “

Device Inventory

” window and click “

Properties

.”

Ensure settings are correct, and make changes if needed.

Select the

Test Hardware

tab.

Verify DaqBook has been properly installed and powered-on. Make sure the parallel port cable

is firmly in place on both the DaqBook and the host PC’s LPT port.

Click the “

Resource Test

” button. This begins the test on DaqBook.

Click the

Test

button.

Device Type Window

Test results should be displayed within a few seconds.

Note that test results have two components:

Resource Tests

and

Performance Tests.

Each is described below.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 61 62

Komentarze do niniejszej Instrukcji

Brak uwag

Measurement-computing Daq PC-Card Instrukcja Użytkownika Strona 13

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Sprzęt komputerowy Measurement-computing Daq PC-Card