Measurement-computing USB-5100 Series Instrukcja Użytkownika Pobierz pdf (Strona 16)

USB-5100 Series Software Help Working with USB-5100 Series Data Loggers

To delete a filtered series, select the series name and click Delete.

Figure 6. Filter Series Dialog Box

4. Repeat steps 1 through 3 to create additional filtered series.

You can create filtered series for all channels and multiple filtered series on a single channel (for example,

you can show the maximum, minimum, and average temperature for a single temperature channel).

5. Click

Done when finished. The number of filtered series that you created is displayed on the Filter button

in the Logger Launch dialog box.

After you launch the logger and read it out, the filtered series is automatically listed in the

Plot Setup dialog,

from which you can select the series you wish to plot.

Note

If you change the GMT offset for the filtered series, the data points do not reflect that change. They do continue

to be filtered based on times within the original GMT offset at launch.

See Filtered Series vs. Statistics Logging for more information.

Configuring a Data Assistant (Scaling)

When you run a Data Assistant from the Launch Logger dialog box, you can create a derived series, which is an

additional data series automatically calculated each time you read out the logger. The Data Assistants dialog

box lists only those assistants available for the currently selected sensor and logger at launch time. There may

be other Data Assistants available for use after reading out the logger.

Complete the following steps to set up a derived series using the Linear Scaling Assistant:

1. Enable one or more channels and enter a name and

LCD units for the channels.

2. Click

Scaling to open the Data Assistants dialog box.

3. Select

Linear Scaling Assistant and click Create.

4. Select the scaling parameters to apply to the selected series and click

Save. The new series is added to the

My Derived Series list.

Note: Although it is possible to set up more than one scaling value for each sensor on the USB-5106, only

the first scaling value for that sensor is used.

The example below shows a scaled series named Percentage set up for the first voltage channel (ch1).

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 63 64

Brak uwag

Measurement-computing USB-5100 Series Instrukcja Użytkownika Strona 16