Measurement-computing Micro488/p Instrukcja Użytkownika Pobierz pdf (Strona 11)

Getting Started

09-26-02

2-1

Getting Started

2.1 Inspection

The Micro488/p was carefully inspected, both mechanically and electrically, prior to

shipment. When you receive the interface, carefully unpack all items from the

shipping carton and check for any obvious signs of physical damage which may

have occurred during shipment. Immediately report any such damage found to the

shipping agent. Remember to retain all shipping materials in the event that shipment

back to the factory becomes necessary.

Every Micro488/p is shipped with the following....

• Micro488/p IEEE488 Bus Controller

• Micro488/p User’s Manual, p/n 232-0901

2.2 Serial Configuration

Some of the Micro488/p serial communication parameters are pre-configured, and

can not be changed. The following list describes the parameters which are fixed

and, therefore, can not be changed:

Parameter Setting

Data Bits 8 Bit ASCII

Stop Bits 1 or 2

Parity None

Receive Terminator CR

The rest of the parameters are configured through software, after power on.

The following is a list of the software-configurable parameters:

Parameter Setting

Baud Rate 300, 1200, 2400, 4800, 9600, 19200

Duplex Full with echo/no-echo

Transmit Terminator LF, CR, LF-CR, CR-LF

Handshaking XON/XOFF or CTS/RTS

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Brak uwag

Measurement-computing Micro488/p Instrukcja Użytkownika Strona 11