Measurement-computing CIO-INT-32 Instrukcja Użytkownika

CIO-INT32User’s ManualRevision 4September, 2000

The voltages and currents associated with external devices range from less than ahundred mA at a few volts for a small flash light bulb to 50 Amps at

3.6 CONNECTOR DIAGRAMThe CIO-INT32 I/O connector is a 50 pin header type connector accessible from therear of the PC through the expansion backplate.

The first I/O address, or BASE ADDRESS, is determined by setting a bank ofswitches on the board.To write to or read from a register in decimal or HEX,

4.0 SPECIFICATIONSTypical for 25°C unless otherwise specified.Power consumption+5V Operating 440 mA typical, 720 mA maxCounter/Timer and Parallel I/O

Interrupt sources Jumper selectable (INT SRC): 8536A interruptoutput, 8536B interrupt output, 8536A OR’edwith 8536B, external (INT INPUT, positiveedg

5.0 ELECTRONICS AND INTERFACING This short, simple introduction to the electronics most often needed by digital I/Oboard users covers a few key co

electrical environment; and unpredictable! This is why it often appears that the Z8536has gone 'high' after power up. The result is that t

Install and solder the SIP in place. Install the SIP with the common pin (dot) in eitherthe HI or LO hole, then solder the SIP in place. A resistor v

The trick to using a voltage divider is to choose two resistors with the properproportions relative to the full scale of the digital input and the max

5.3 LOW PASS FILTERS DE-BOUNCE INPUTSA low pass filter is placed on the signal wires between a signal and an A/D board. Itstops frequencies greater t

(C) Copyright 2000 Measurement Computing Corp.HM CIO-INT32.lwpYour new Measurement Computing product comes with a fantastic extra — Management committ

For your notes.16

For your notes.17

For your notes.18

EC Declaration of ConformityWe, Measurement Computing Corp., declare under sole responsibility that theproduct:Interrupt vector boardCIO-INT32Descript

Measurement Computing Corporation 10 Commerce Way Suite 1008 Norton, Massachusetts 02766 (508) 946-5100 Fax: (508) 946-9500 E-mail: [email protected]

Table of Contents155.3 LOW PASS FILTERS DE-BOUNCE INPUTS ...135.2 VOLTAGE DIVIDERS ...115.1

This page is blank.

1.0 INTRODUCTIONThis manual provides technical information for the CIO-INT32. It is intended to beused with the ZILOG 8536 integrated circuit data sh

2.0 SOFTWARE INSTALLATIONIn order to easily test your installation, it is recommended that you install InstaCal, theinstallation, calibration and test

Certain address are used by the PC, others are free and may be used by theCIO-INT32 and other expansion boards. We recommend BASE = 300H (768D) betri

Table 2. Available IRQs Note: IRQ8-15 are AT onlyLPTIRQ7UNASSIGNEDIRQ15FLOPPY DISKIRQ6HARD DISKIRQ14HARD DISK (AT)LPT (AT)IRQ580287 NUMERIC CO-PIRQ13

The interrupt output from the Z8536 or connector must be routed to the PC bus. Theinterrupt jumper allows you to choose a PC interrupt in the range 2