Measurement-computing ZonicBook-Medallion rev.5.0 Instrukcja Użytkownika Pobierz pdf (Strona 11)

Hardware Setup

Configuring Channels via DIP-Switches

ZonicBook channel configuration is determined by DIP-switch settings. The default setting is “Single

Ended, A.C. Coupled ICP (Off).” Possible settings are illustrated below.

CAUTION

Each channel must have its associated DIP-switch properly set to achieve the desired

configuration, as determined by your application. Improper settings can damage

your equipment, and will produce erroneous measurements.

To set the switches:

1. Ensure the ZonicBook is disconnected from power, the PC, and all signal lines.

2. Remove ZonicBook’s bottom cover plate.

3. Set each channel’s DIP-switch according to the desired configuration.

Refer to other documentation if needed.

4. Replace the bottom cover plate.

5. For 16-Channel ZonicBook’s only.

(a) After setting the DIP-switches for Channels 1 through 8,

replace the bottom cover plate.

(b) Remove the top cover plate.

(d) Replace the top cover plate.

Default

Channel DIP-Switch Settings

ZonicBook-Medallion 889596 Getting Started, pg. 5

1 2 ... 6 7 8 9 10 11 12 13 14

Brak uwag

Measurement-computing ZonicBook-Medallion rev.5.0 Instrukcja Użytkownika Strona 11