Measurement-computing SC-1608 Series Instrukcja Użytkownika Pobierz pdf (Strona 14)

Chapter 3

Functional Details

This chapter discusses the functional details of the SCC-8-8-2 baseboard. For functional details of the OEM

DAQ board, refer to the hardware manual specific to the SC-1608 Series;

 USB-1608GX-2AO-OEM: www.mccdaq.com/PDFs/manuals/USB-1608GX-2AO-OEM.pdf

 USB-1608GX-OEM: www.mccdaq.com/PDFs/manuals/USB-1608GX-OEM.pdf

 USB-1608G-OEM: www.mccdaq.com/PDFs/manuals/USB-1608G-OEM.pdf

 E-1608-OEM: www.mccdaq.com/PDFs/manuals/E-1608-OEM.pdf

SCC-8-8-2 baseboard components

The location of each component on the baseboard is shown in Figure 4.

External power connectors J1 and J2

8B I/O module control jumpers J29 and J30 (for CH8)

J29: AOUT0 readback or convert to input module location

J30: AOUT0 voltage divider

E-1608-OEM connectors J3, J4, and J37

8B I/O module control jumpers J31 and J32 (for CH9)

J31: AOUT1 readback or convert to input module location

J32: AOUT1 voltage divider

8-position DIP switch for SSR module direction

8B I/O module mounting locations CH8 and CH9

Non-invert/Invert logic control jumper W1

CJC Enable jumpers J21 to J28

USB-1608G-OEM Series connectors J5to J6

R1 - R8 resistor locations

SSR I/O module mounting locations SSR0 to SSR7

8B module screw terminals

SSR I/O module status LEDs (8)

SSR I/O module screw terminals

User I/O header connector J35

Power switch SW1

8B input module mounting locations CH0 to CH7

Figure 4. SCC-8-8-2 baseboard components

External power connectors

External power can be connected to either power connector J1 (barrel connector) or J2 (terminal block). Do not

attempt to apply power to both power connectors simultaneously.

 Connector J1 connects to the +12 VDC external power supply included in the SCC-8-8-2 shipment.

 Connector J2 connects to a user-supplied +12 VDC power supply.

Figure 5 shows a schematic for external power connectors J1 and J2.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 33 34

Brak uwag

Measurement-computing SC-1608 Series Instrukcja Użytkownika Strona 14