Measurement-computing PCI-DIO24H Instrukcja Użytkownika Pobierz pdf (Strona 13)

PCI-DIO24H User's Guide Functional Details

Signal level control

All I/O bits are set to a high impedance input mode on power up and reset. To prevent unwanted signal levels,

and to drive all inputs on the device you are controlling to a known state after power up or reset, install pull-up

or pull-down resistors.

A pull-up resistor pulls all digital pins up to +5 V (high logic level). A pull-down resistor pulls all digital pins

down to 0 V (low logic level).

The PCI-DIO24H has open locations where you can install a 2.2 K , eight-resistor single inline package (SIP)

resistor network for each port. The SIP is made up of eight 2.2 K resistors. One side of each resistor is

connected to a single common point and brought out to a pin. The common line is marked with a dot or line at

one end of the SIP. The remaining resistor ends are brought out to the other eight pins (see Figure 5).

2.2KOhm SIP

Dot

(LO or HI)

I/O Lines

Figure 5. Eight-resistor SIP schematic

Install the SIP on the PCI-DIO24H board at the locations labeled PORT A, PORT B and PORT C (adjacent to

the 37-pin connector). Figure 6 shows a schematic of an SIP installed in both the pull-up and pull-down

positions.

2.2 K SIP installed for pull-up

2.2 K SIP

Dot indicates the

common line

+5 VDC

(GND)

User Connector

Digital I/O Lines

COM

Digital

I/O Port

n = A, B, or C

+5 VDC

2.2 K SIP installed for pull-down

2.2 K SIP

Dot indicates the

common line

(GND)

User Connector

Digital I/O Lines

COM

Digital

I/O Port

n = A, B, or C

Figure 6. Pull-up and pull-down resistor SIP schematic

When installed, the SIP establishes either a high or low logic level at each of the eight I/O lines on the port. At

each board location, A, B, and C, there are 10 holes in a line. The hole on one end is marked "HI" and is

connected to +5V. The other end is marked "LO" and is connected to GND. The eight holes in the middle

connect to eight lines of the port, A, B or C.

To pull-up lines, orient the SIP with the common pin (dot) toward the HI end; to pull-down, install the resistor

with the common pin in the LO hole.

Note:

We recommend using 2.2K SIPs (MCC part number SP-K2.29C). Use a different value only if necessary.

1 2 ... 8 9 10 11 12 13 14 15 16 17

Komentarze do niniejszej Instrukcji

Brak uwag

Measurement-computing PCI-DIO24H Instrukcja Użytkownika Strona 13

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Sprzęt komputerowy Measurement-computing PCI-DIO24H