Measurement-computing eZ-Analyst rev.14.1 Instrukcja Użytkownika Pobierz pdf (Strona 78)

4-42 Edit Menu 978791 eZ-Analyst

Edit Menu > Output Channel Setup

ZonicBook/618E and WaveBook Waveform Output …… 4-42

640u and 640e Waveform Output …… 4-44

The Output Channel window can be accessed directly from the Edit pull-down menu [when in

the measurement mode]. In all cases, the setup is performed on a channel-by-channel basis.

Configuration changes are accepted as soon as the <Apply> or <OK> button is clicked.

ZonicBook/618E and WaveBook Waveform Output

WARNING

When the Signal Generator is started [in eZ-Analyst] the device that is

connected to Source Output will receive excitation and could possibly

cause injury to personnel. Be aware of which device is receiving

excitation and post adequate notice to keep individuals and physical

objects clear of the device.

Do not confuse the Output Source [excitation source] with source level,

as the latter term refers to transducer bias current.

The Source Output can be used as a test source for the input channels or as excitation for

other system elements, such as the amplifier for a shaker table. All source output parameters

are software controlled and the actual output signal leaves the device through a front panel

BNC connector.

Note: The Control pull-down menu can be used to turn the Signal Generator “On.”

In regard to ZonicBook/618E – Source Output is supported for device and for attached

WBK18 modules.

In regard to WaveBooks – Source Output is only supported when eZ-Analyst detects attached

WBK14 or WBK18 expansion units.

For both the ZonicBook/618E and WaveBooks, the Output Channel (Excitation Source) can be

for either a continuously running sine wave or a swept sine wave.

Output Channel Setup, WaveBook and ZonicBook/618E Applications

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 135 136

Brak uwag

Measurement-computing eZ-Analyst rev.14.1 Instrukcja Użytkownika Strona 78