Measurement-computing Digital232 Instrukcja Użytkownika Strona 46

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 59
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 45
Section 3 Command Descriptions
3.24
EXECUTE X
Commands sent to the
Digital232
will result in no action until the unit is
instructed to execute these commands. This is done by sending an
X
command or a
serial terminator, which is usually the last character of a command string. Commands
sent without an
X
are stored in the internal buffer until an
X
or a serial terminator is
received. Any number of
Execute
commands may be inserted into the same command
string. Certain commands, such as
Bit Set
require an
X
after each command in a
string if more than one of that command is within the same string.
Example:
@
reset the
Digital232
A1XA2
two
Bit Set
commands are within the
same string, requiring an
X
after each
command (unless separated by a terminator)
Przeglądanie stron 45
1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 58 59

Komentarze do niniejszej Instrukcji

Brak uwag