Measurement-computing CIO-DAC02/16 Instrukcja Użytkownika Pobierz pdf (Strona 8)

Use Switch bank S1 to select the output range of Channel 0.

Use Switch bank S2 to select the output range of Channel 1.

Table 3-2. Range Selection Switch Positions

DDUDU0 to 2.5V

UDUDU0 to 5V

DUUDU0 to 10V

DDDUD+

2.5V

UDDUD+

DUDUD+

10V

5432

RANGE

Figure 3-3. Range Switch Block - +10V Example Shown

3.4 INSTALLING THE CIO-DAC02/16 IN THE COMPUTER

1. Turn the power off.

2. Remove the cover of your computer. Be careful not to dislodge any of the cables

installed on the boards in your computer as you slide the cover off.

3. Locate an empty expansion slot in your computer.

4. Push the board firmly down into the expansion bus connector. If it is not seated

fully it may fail to work and could short circuit the PC bus power onto a PC bus

signal. This could damage the motherboard in your PC as well as the

CIO-DAC02/16.

Range switches set for +10V

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Brak uwag

Measurement-computing CIO-DAC02/16 Instrukcja Użytkownika Strona 8