Measurement-computing 2000 Series Daqboar Instrukcja Użytkownika Pobierz pdf (Strona 87)

DaqBoard/2000 Series and /2000c Series User’s Manual

07-02-01

CE-Compliance 3-5

For cPCI DaqBoard/2000c Series Boards [cPCI Type]

If you a installing the cPCI DaqBoard/2000c Series Board for the first time, refer to chapter 2 of this

manual; or to the cPCI DaqBoard/2000c Series Quick Start Guide, prior to installing the board.

Turn the compact PC’s power OFF.

Turn power OFF to externally connected

equipment.

UNPLUG the compact PC and all

externally connected equipment.

With the board’s injector/ejector down,

slide the board into the compact PC.

Make sure you use the PCs card guides.

After the board is inserted, pull the cPCI

board’s injector/ejector up to engage the

board.

Tighten the upper and lower lock screws.

Connect the CA-195CE Cable to the Board

Note: This section includes illustrations depicting the DaqBoard/2000; but apply to both the

DaqBoard/2000 Series Boards and the cPCI DaqBoard/2000c Series Boards.

Note: When mating P4 connectors, ensure that the P4 white locator triangles

point to each other. The triangles locate pin A1.

1. Connect one end of the CA-195CE Cable to DaqBoard/2000 Series [or /2000c Series] Board’s P4

connector. Note that either end of the cable can be connected to the board; however, the white locator

triangles must align with each other.

Align the Cable Clamp (1033-2009) with the

CE ORB and secure the items with two

4-40 x 3/16 screws (provided).

Note: In the right hand figure, the cable is not shown to

allow for greater clarity of parts.

Installing a cPCI DaqBoard/2000c Series Board

ower Lock Screw

pper Lock Screw

njector/

jector

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 93 94

Brak uwag

Measurement-computing 2000 Series Daqboar Instrukcja Użytkownika Strona 87